Wall (faces mbili) + area threshold rule
Ingizo L=6000mm, H=3000mm, faces=2, openings: 900×2100mm×1 / 300×300mm×2, threshold=0.50m²
Matokeo Gross 36.00m², opening deduction 17.82m², net 18.18m²
Kikokotoo cha Eneo la Formwork (m²/ft²)
Kokotoa eneo la formwork kwa kila member na uchague opening deduction rules ili kupata net area.
Ufafanuzi wa surface na formulas hubaki kuonekana ili masharti maalum ya mradi yawe rahisi kueleza.
Inaunga mkono Column / Beam / Wall / Slab edge
Opening rules zenye templates na njia wazi ya kuhariri
Data yote huchakatwa ndani ya browser yako
Jinsi ya kutumia
- Chagua unit mode (m² au ft²) na member type.
- Weka member dimensions na quantity, kisha thibitisha target surfaces na formula.
- Ongeza opening rows na weka deduction faces na deduction rule.
- Kagua net area na multiplier-based reference value, kisha nakili share link inapohitajika.
Mifano
Beam (side + bottom)
Ingizo B=300mm, D=600mm, L=4500mm, qty=2, end faces off
Matokeo Hukokotolewa kwa side na bottom pekee, beam top ikiachwa nje
FAQ
Je, beam top face inajumuishwa?
Hapana kwa chaguo la msingi. Hesabu ya beam inalenga side faces na bottom face, huku end faces zikiwa chaguo la hiari.
Kwa wall openings, deduction ni upande mmoja au pande zote mbili?
Tabia ya msingi hufuata member face count kiotomatiki. Unaweza ku-override deduction faces inapohitajika.
Je, openings ndogo zinaweza kutotolewa kwenye deduction?
Ndiyo. Tumia area-threshold au dimension-threshold template kuacha openings zilizo chini ya vizingiti.
Je, multiplier result ni cost estimate?
Hapana. Multiplier output ni reference area value, si hesabu ya gharama.
Naweza kuhifadhi company-specific defaults?
Ndiyo. Tumia rule editor kuhifadhi defaults ndani ya browser hii.