Renovation case with half-perimeter coverage
Inntak
Perimeter 48.6m / Height 6.0m / Coverage 0.50 / Mesh ON (10%) / Protection ON (15%)
Úttak
Scaffolding area 145.8m², Mesh 160.4m², Protection 167.7m²
Scaffolding Area Estimate (Perimeter × Height + Accessory Area)
If you have drawings, enter perimeter directly. If not, estimate it from shape and get a one-minute rough quantity.
This is for estimating and pre-áætlunning only. It must not be used for scaffold design, strength checks, or safety áætlunning.
Perimeter inntak: direct value or shape-based estimate
Coverage factor and covered perimeter shown together
Safety-use restriction shown at all times
Important Notice
- Safety requirements come first. This verkfæri provides rough estimates and does not replace scaffold design, strength checks, or safety áætlunning.
- For actual work, follow site conditions, regulations, specifications, and the contractor's standards.
What this verkfæri does
- Calculates scaffolding area instantly from perimeter × height × coverage factor.
- Shows covered perimeter alongside coverage factor so assumptions are easy to verify.
- Calculates mesh sheet and protection area with loss in the same niðurstaða panel.
- Supports URL sharing and copy-ready úttak for repeat use.
How to use
- In Step 1, enter perimeter directly or estimate it from shape.
- In Step 2, set scaffold height and coverage factor.
- In Step 3, optionally enable mesh/protection and set loss rates.
- Yfirferð the niðurstaða card, then copy values or share via URL.
Sample
Adopt perimeter from rectangle estimate
Inntak
L=12m, W=10m -> Adopted perimeter 44m / Height 8m / Coverage 0.75
Úttak
Scaffolding area 264.0m²
Formulas
- Scaffolding area A = Perimeter × Scaffold height × Coverage factor
- Covered perimeter = Perimeter × Coverage factor
- Accessory area = A × (1 + Loss rate)
Algengar spurningar
What is coverage factor?
It is the portion of the building perimeter where scaffolding is installed. Typical references are 1.0 for full perimeter and 0.5 for half perimeter.
Should I inntak coverage factor or covered perimeter?
Either is fine. If you enter covered perimeter directly, the coverage factor is back-calculated automatically.
Can this úttak be used for safety áætlunning?
No. This verkfæri is for rough quantity estimation only. Actual work decisions must be made by qualified professionals and contractors.
Can I estimate mesh sheet count?
Yes. In the reference panel, select sheet size and overlap to get an approximate sheet count.
How many sides can polygon inntak handle?
You can inntak 3 to 12 sides. For highly irregular shapes, direct measured perimeter is recommended.
Athugasemdir
- This verkfæri is an estimate. Actual quantities vary significantly by building geometry, ground conditions, nearby obstacles, regulations, and contractor standards.
- Safety requirements always take priority. This verkfæri is not intended for scaffold design, strength checks, or safety áætlunning.
- Actual execution must be performed under qualified professional and contractor judgment.