Թիրախային DFT-ից, ծավալային պինդ նյութերից, կորուստի տոկոսից և մակերեսից հետհաշվեք անհրաժեշտ WFT-ը և փաստացի նյութի օգտագործումը։
Փոխվեք միկրոնների և միլերի միջև՝ աշխատելով արդյունաբերական ծածկույթի փուլերով, ներառյալ ծանրաբեռնված ծածկույթի աշխատանքները։
Մուտք Area 100 m², loss rate 10%, Primer: DFT 75 µm, volume solids 80%, 1 coat, area share 100%, Topcoat: DFT 50 µm, volume solids 65%, 2 coats, area share 100%
Ելք Primer WFT 93.75 µm, theoretical coverage 10.67 m²/L, usage 10.42 L. Topcoat WFT 76.92 µm, theoretical coverage 13.00 m²/L, usage 17.09 L. Total 27.51 L.
Մուտք Area 10,000 ft², loss rate 10%, Stripe coat: DFT 3 mil, volume solids 80%, 1 coat, area share 25%
Ելք WFT 3.75 mil, theoretical coverage 427.78 ft²/gal, effective coverage 385.00 ft²/gal, actual usage 6.49 gal.
Dry film thickness left after curing. This is the main figure used in specifications and inspection criteria.
Wet film thickness immediately after application. Only the solids remain after drying.
The share of volume that remains as film. Use volume solids for thickness conversion.
A no-loss coverage estimate derived from WFT.
The share of total area assigned to a stage, such as stripe coat or touch-up work.
WFT is the film thickness right after application, while DFT is the film thickness left after drying. Volume solids are used to convert between them.
No. Use volume solids for thickness conversion. If you only have weight solids, convert them separately first.
Use a value that matches the application method, geometry, and your field experience. Higher overspray usually means a higher loss rate.
Yes. Leave area blank if you only need the WFT and theoretical coverage calculation.
No. Keep the entire calculation in one unit system at a time.