Planeerieeri, kust tüve lõigata, lähtudes pikkusest, kitsenemisest, defektide asukohtadest, toote pikkustest, kvaliteediklassidest ja hindadest.
Vaheta väärtuse, saagikuse ja tükkide arvu prioriteetide vahel, et võrrelda erinevaid tüve tükeldamise strateegiaid samal ekraanil.
Kasutajad saavad määrata toote pikkusi, kvaliteediklasse ja hinnatabeleid kohalikele turgudele kõikjal maailmas.
Sisend: Tüve pikkus 10 m, butt diameeter 40 cm, top diameeter 20 cm, toode pikkuss 4 m and 2 m, prices 4 m = 80 and 2 m = 38, no defects, objective = väärtus
Väljund: 4 m x 2 tükid and 2 m x 1 tükk, total väärtus 176, saagikus 100%
Sisend: Tüve pikkus 10 m, toode pikkuss 5 m and 1 m, prices 5 m = 100 and 1 m = 5, objective = arv
Väljund: 1 m x 10 tükid, total väärtus 50, tükk arv 10
Sisend: Tüve pikkus 10 m, blocking defekt from 4.8 m to 5.2 m, toode pikkuss 5 m and 1 m
Väljund: See 5 m tüvi is excluded by the defekt, so the planeeri falls back to 1 m tükid or waste
Yes. Lisa ridas to the tables and define different standards for each turg or buyer.
Väärtus prioritizes hind, saagikus prioritizes saleable pikkus or maht, and arv prioritizes the number of tükid.
Yes. Sisesta them as very short ranges if needed, and use the defekt buffer to widen the protected zone.
Yes. Pikkus and diameeter units can both be switched. Internal calculations are normalized behind the scenes.
No. This version expects you to define the hind table yourself for the turg you work in.
See process of cutting a stem into tüved with specific toode pikkuss.
See rate at which diameeter becomes smaller from the butt toward the top.
See diameeter on the thinner end of a tüvi. It is often used for kalle checks.
See saw laius lost during cutting.
A defekt area that makes a candidate cut infeasible when crossed.
A kalle such as A, B, or C that is tied to a hind table.